I am currently transfering a working computer from an old case to a new one.
Having successfully transfered all of the hardware and put all of the powere ide and other cables in place I boot up PC, at this stage I get power to HDD,CDR,Floppy but fail to get the comforting BIP noise and then obviosly nothing to the screen.
My presumption is that the jumper settings are incorrect for power hdd etc, however after download manual from the biostar site they are correct I have tried many differant combinations but still the same result.
This motherbards was working fine in the old case
Motherboards is a Biostar M7VIQ
The case is an atx with hdd lead,power lead + and - ,Reset Switch and Power switch.
I am at a total loss .
I have tried differant Ram
Used PSU from Old case
Any advice would be gratefully recieved
Cheers in advance Pete