[vicng93]

i was using pc for a while and suddenly it restarts. why does this happen? it happened quite a few times already.

[Advertisements]

have you added any new hardware or software recently...
updated windows or any other software just prior to having the problem...
what are you doing when you have the problem....
have you tried system restore yet...


Bad computer memory is one of the three main reasons for random system failures.. the other two are heat (usually
caused by fans or heatsinks being blocked with dust) or power issues...

first...
lets make sure its not your memory going bad...get memtest + here....
the lowdown is here..

if you have a floppy drive you can get the 6th one down ...
set the bios to boot from the floppy drive A: first...then the cd drive then the Hard drive C:

or you can get the 2nd one down and burn the ISO file to a cd and then boot it from the cd drive...

if you don't have a burning program that will burn .ISO files go
here and get burncdcc ..a small FAST no frills iso
burning program...

NOTE...do not put a blank cd in until burncdcc opens the tray for you
1. Start BurnCDCC
2. Browse to the ISO file you want to burn on cd/dvd ....in this case its memtest86.iso
3. Select the ISO file
4. click on Start

make sure in the bios the cd drive is the first boot device....put the cd in the cd drive..boot your computer....


let memtest run for at least 2 hours...if it starts showing any errors during that time then you will have

to replace the RAM...no errors after 2 hours just press Esc to end the tests and we will try some other

tests


go here and get everest home...install and

launch it...click the + by computer...click on sensor...get a screenshot and post it so I can check your temps and

voltages...

Edited by happyrck, 14 July 2008 - 06:29 PM.

[happyrock]

have you added any new hardware or software recently...
updated windows or any other software just prior to having the problem...
what are you doing when you have the problem....
have you tried system restore yet...


Bad computer memory is one of the three main reasons for random system failures.. the other two are heat (usually
caused by fans or heatsinks being blocked with dust) or power issues...

first...
lets make sure its not your memory going bad...get memtest + here....
the lowdown is here..

if you have a floppy drive you can get the 6th one down ...
set the bios to boot from the floppy drive A: first...then the cd drive then the Hard drive C:

or you can get the 2nd one down and burn the ISO file to a cd and then boot it from the cd drive...

if you don't have a burning program that will burn .ISO files go
here and get burncdcc ..a small FAST no frills iso
burning program...

NOTE...do not put a blank cd in until burncdcc opens the tray for you
1. Start BurnCDCC
2. Browse to the ISO file you want to burn on cd/dvd ....in this case its memtest86.iso
3. Select the ISO file
4. click on Start

make sure in the bios the cd drive is the first boot device....put the cd in the cd drive..boot your computer....


let memtest run for at least 2 hours...if it starts showing any errors during that time then you will have

to replace the RAM...no errors after 2 hours just press Esc to end the tests and we will try some other

tests


go here and get everest home...install and

launch it...click the + by computer...click on sensor...get a screenshot and post it so I can check your temps and

voltages...

Edited by happyrck, 14 July 2008 - 06:29 PM.