Jump to content

Welcome to Geeks to Go - Register now for FREE

Geeks To Go is a helpful hub, where thousands of volunteer geeks quickly serve friendly answers and support. Check out the forums and get free advice from the experts. Register now to gain access to all of our features, it's FREE and only takes one minute. Once registered and logged in, you will be able to create topics, post replies to existing threads, give reputation to your fellow members, get your own private messenger, post status updates, manage your profile and so much more.

Create Account How it Works

Overclocking RAM

  • Please log in to reply



    New Member

  • Member
  • Pip
  • 2 posts
I am trying to overclock my ram... my ram specs are as follows

Model F2-6400CL5D-2GBNQ
Type 240-Pin DDR2 SDRAM
Tech Spec
Capacity 2GB (2 x 1GB)
Speed DDR2 800 (PC2 6400)
Cas Latency 5
Timing 5-5-5-15
Voltage 1.8V - 2.0V
Buffered/Registered Unbuffered
Heat Spreader Yes

my motherboard supports 1.8v ram. however, this board was built for overclocking, so i had no problems uping the ram to 1.95v. this is well within the recommended voltage so it shouldnt be a problem. i have read that many people are running this ram stable at 4-4-4-12 and would love to achieve those same timings. so i went into the bios and got a lot of different options. i have no idea which ones to change and how they will effect ram speeds etc. also i would like to know if changing this timing will effect my FSB(HTT):RAM ratio, or if that is only effected by increasing the MHz on the ram.

if someone could explain the items that are listed in my bios and what ones to change to acheive these timings, please let me know.

CAS # Latency = [5t]
1t/2t Command Timing = [2t]
Twtr Command Delay = [3t]
Trfc0 for DIMM1 = 105ns
Trfc2 for DIMM2 = 75ns
Trfc1 for DIMM3 = 75ns
Trfc3 for DIMM4 = 75ns
write recovery time = [6t]
precharge time = [2t]
Row cycle time = [21t]
RAS to CAS R/W delay = [5t]
RAS to RAS delay = [3t]
Row precharge time = [5t]
minimum RAS active time = [15t]

DDRII voltage control = 1.8v [+.15v]

please let me know what i need to change, and if you could, please inform me on what the rest of the info here means.

thank you very much in advance,
  • 0


Similar Topics

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users

As Featured On:

Microsoft Yahoo BBC MSN PC Magazine Washington Post HP