[datarunner]

I am just not seeing what you are looking at in either Firefox or IE. Possibly I don't understand the problem. The image mentioned is centered on the page. There is some slight differences in opacity between the browsers, but you may not have coded for both browsers.

Been up all night working on pages so may not get back to you until later tonight.

Hi There

Fixed it buddy

If you have a look now you'll see what I meant

Many thanks for your time, patience and expertise on this

Regards

[Advertisements]

You're welcome. Glad you managed to get it working while I slept. . Might post your steps used if you can just in case another user(s) may have been following this thread.

[Major Payne]

You're welcome. Glad you managed to get it working while I slept. . Might post your steps used if you can just in case another user(s) may have been following this thread.

[Bulla]

Hi,
My first visit, awesome place to be !!
I have the same problem, and would appreciate the input, I have replaced the logo on the template with my own, but cant get it re sized to show properly.

This is my e commerce site, (still adding to it, not fully operational and not ready for e commerce yet)
www.pcinc.co.za

here is a similar site, using the same template, and you can see how they did there logo.

www.pcbunny.co.za

Thanks in advance!

PS, The only way my Logo is showing at the moment,is that I placed it in the Advertising module on the top of the page, and as you can see, it moved the frame down.

Edited by Bulla, 30 August 2009 - 03:55 AM.

[rshaffer61]

Direct to: Bulla

Please start your own topic
Although your issue may seem similar there can be other factors that may need to be resolved.
By bumping on someone's topic it makes it confusing for the tech to understand who they are helping. This can in turn cause the wrong support to be given and can cause instability or worse to happen to your system. Thank you for your cooperation.

[Bulla]

You're welcome. Glad you managed to get it working while I slept. . Might post your steps used if you can just in case another user(s) may have been following this thread.

Read the above, that's the reason I posted here, and bumped it, seeing its a similar problem, I was hoping the poster will post the steps. gettit?

[Major Payne]

As already stated, you need to start your own topic. You could have done that and referenced this one from your own topic then we all would have a good beginning. If OP here does not want to post back with their solution, that's their decision, but we can't keep helping you in their topic as all email replies go to all who subscribed to this topic. Thank you for your cooperation.

[Bulla]

Well, so much for the awesome help I expected.

[Major Payne]

Well, so much for the awesome help I expected.

You don't read the Terms of Use and the Stickies in forum sections, what do you expect? You were told DIRECTLY not to hi-jack someone else's post and to start your own. Glad to help you, but not when you will not pay attention to directions.