Welcome to Geeks to Go - Register now for FREE

Need help with your computer or device? Want to learn new tech skills? You're in the right place!
Geeks to Go is a friendly community of tech experts who can solve any problem you have. Just create a free account and post your question. Our volunteers will reply quickly and guide you through the steps. Don't let tech troubles stop you. Join Geeks to Go now and get the support you need!

Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

cannot detect master and slave drive at same time in bio's

Started by sandige , May 06 2011 11:20 PM

Please log in to reply

#1
sandige

Posted 06 May 2011 - 11:20 PM

New Member

Member
5 posts

ok, so i just posted about having problems detecting new hard drive i installed. just to see what would happen i booted again and went straight into bio's. it detected my master drive, but no sign of the slave.
so, i rebooted only this time i disconnected the master, only leaving the slave attached. when bio's came up there was my slave. even booted saying it was a slave drive.
all the jumpers are correct, all the cables work. i have tried running them CS as well. no luck.
what would cause the slave to be undetectable while the master is connected, but show when no master is present?