[Hopper697]

Installed new asus P8Z68-v motherboard cpu fan spins far one second and stops. Repeats after re-powering.

[Advertisements]

Hi Hopper697
Best couple of suggestions I can make would be first remove the MB and do a barebones set-up on a piece of cardboard (make sure it is larger than the MB) only connect the PSU, the GFX card, 1 stick of Ram and the keyboard.
You will then need to short out the 2 power on pins on the MB header to get the PSU to activate, you can use a small flat bladed screwdriver or a paper clip bent into a U shape, this is perfectly safe if you do not touch anything else, the idea is to see if we can get a BIOS screen if you do you can then add one component at a time until you find the problem component, you must power down and remove the power cord from the wall before adding a component, second suggestion try a known working PSU.
Other things worth checking include, if you used stand offs beneath the MB are they in the correct locations (only where there is a screw hole in the MB) otherwise the MB will short out, check for stray screws or bared wires for the same reason, make sure the jumper cap that can be used for clearing the CMOS is not missing or on the wrong pins.

[phillpower2]

Hi Hopper697
Best couple of suggestions I can make would be first remove the MB and do a barebones set-up on a piece of cardboard (make sure it is larger than the MB) only connect the PSU, the GFX card, 1 stick of Ram and the keyboard.
You will then need to short out the 2 power on pins on the MB header to get the PSU to activate, you can use a small flat bladed screwdriver or a paper clip bent into a U shape, this is perfectly safe if you do not touch anything else, the idea is to see if we can get a BIOS screen if you do you can then add one component at a time until you find the problem component, you must power down and remove the power cord from the wall before adding a component, second suggestion try a known working PSU.
Other things worth checking include, if you used stand offs beneath the MB are they in the correct locations (only where there is a screw hole in the MB) otherwise the MB will short out, check for stray screws or bared wires for the same reason, make sure the jumper cap that can be used for clearing the CMOS is not missing or on the wrong pins.