We moved to a different ISP so i had to re-configure the EDIMAX which was set up as a repeater and used to work great. Now for some reason i wasn't able to do that..
The weird thing is, it was working for few seconds and then the signal was lost (you were able to connect to the EDIMAX repeater but there was no internet.
Below are some of the configurations that i made which i think might be the cause:
1. I set up the EDIMAX repeater with IP that end with 200 (192.168.1.200). The reason i did it was because know that if the main router is modem-router, this is the IP i should configure.
2. I was told not to set up encryption WPA2-PSK AES as it is "problematic" but it was my only choice as the main router (D-link DSL-225) doesn't support WEP encryption. I don't want of-course to just leave it open.
3. I disabled DHCP because the instructions asked for it but i'm not sure it was the correct way to go.
That's it basically. I will try to play with it a bit more but if someone can assist me to get this done better and faster I WILL APPRECIATE IT A LOT
If i will be able to solve it (i doubt it though), i will write what was done here.
Thank you very much!