For my graphic card. wich is a (click link:: http://www.sohodiffu...it.asp?num=9655 )
Name of card: ASUS EAH4870/HTDI/512M RADEON HD4870 512M-DDR5 256BIT DUAL DVI-I HDMI HDTV PCI-E 2.0
And when i run the setup driver/utilities disk... running utilities is fine however drivers...itll install until , almost at the end... i see this message and thus the install stops.
this message says it cannot find a file... and also.. this message also pops if i want to run the Cpontrol center to you know.. control my graphic card's capacities...
here is link to image(mod'ed screenshot) of the message:


(if picture doesnt load: direct link here: http://img111.images...easusvgarp1.jpg
So basically.. what can I dpo to fix this issue and so i can fully install drivers and futur drivers and access to Control center? =)
note: i dont know if its anything special but i have 2 ProgramFile files. a normal ProgramFiles and a ProgramFiles(x86)... so far most stuff installs on the x86 one. Im guessing its normal.
-Shuh
Note: Link to the post showing what I purchased: http://www.geekstogo...ld-t209106.html
Edited by Shuh, 19 September 2008 - 08:08 PM.