Booting problems - RESOLVED
Started by
dnrflorence
, Jun 02 2006 09:26 PM
#16
Posted 23 June 2006 - 06:14 PM
#17
Posted 23 June 2006 - 06:56 PM
Hi. Glad you've figured it out, I suspected something like that was the problem which is why I asked you to check the master/slave assignment in the bios!
Re. CS jumper - if this works, then fine. To be honest though, normally you don't use CS when a drive is on its own on the cable (ie no slave), generally you would jumper the drive as either 'master' or 'single' depending on the available config options are. But like I said, if its working, then leave it alone.
I'll mark the thread as resolved fore you
Re. CS jumper - if this works, then fine. To be honest though, normally you don't use CS when a drive is on its own on the cable (ie no slave), generally you would jumper the drive as either 'master' or 'single' depending on the available config options are. But like I said, if its working, then leave it alone.
I'll mark the thread as resolved fore you
Similar Topics
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users