I am a complete Noob where overclocking is concerned. I read quite a bit of info on overclocking so I decided to have a little go. This is what I did and I would appreciate your comments , please. As my fsb was 200mhz I put that up to 205 and ran the Go- Orthos and cpu-z programs. After 4 pass results with Go- Orthos, here was the cpu z results.
Mem freq 102.5
Command rate 2T
HT Link 820.01
Bus speed 205
I then decided to up the fsb by 2 noches to 207. That ran ok.
Then I put it up the fsb up to 210.
Speed 2520.3 mhz
Mult x 12
HT Link 840.1
Mem freq 105 mhz
Fsb dram 24
After running the Go- Orthos for a few minutes it all went Red and stopped. I have put the fsb back to 107. As you can see I am not too well up on overclocking. Look forward to hearing from any one.
Cheers